High end crossovers




	The High end deception


	The component with the smallest sound value affects the entire crossover!


		Loudspeaker Crossovers of high end manufacturer, which we would not like to withhold from you.



			Low End


	The term "High end" can be abused for much. We count 5 components, which holds an High ending is suited. Only Middle End.

Here we do not see High end components unit. Die Zero ohm of coils have a too large THD, about 400 Hz and > -40 dB.

As Sub bass, under 200 Hz, OK

The money was missing here, if a galvanized flat pin of the cheapest design is taken.

Here a good example, what in such a way magazines everything for a muck the people is jubilant. I see whole 3 noble components units more not i.e., the 3 Foil-inductors and.

I personally finds the cable straps for an High end Loudspeaker horrible. And heavily found, off componets unit value about 150 euro.

Elkos and cheap airinductors do not belong now once into this category of loudspeakers to be silent from the sound completely.

Approve of Air-inductors four Capacitors of Mundorf (M-Cap), evaluation 7, also only Middle end.

Who from High end speaks, must the components also use. Because a selected Elko, remains sounded a Elko etc.. Some what more honesty well to face would stand for the Factory.

Here once a mixed example. On the right of Mundorf very good Capacitors there and more over it approve of Audyn Caps. At the coils still more one saved. If one counts everything together, also only Middle end comes out with.

That is noble High end, up to two of small resistances is everything of the finest one nevertheless. Such a thing High end loudspeaker, all attention Tony Gee belongs into a super!

Cable strap (Brrrr........)


	The biggest lies from: Peter Aczel


	Continuation follows.

Right: In addition, the coils look like Tritec, can be cheap air-coils. Capacitors without label, either m-Cap or nor cheaper Polipropilen of unknown quantity origin.

Middle-End to Low-End.